Roofing/Siding Rollformer

This machine can be tooled to produce any required roofing or siding profile.

Note: Overall sizes may vary, depending on profile.

20m/min typical line speed
fully fabricated and powdercoated frame
adjustable infeed guiding unit
lubricating unit (only required if galvanised material is to be used)
hard chromed rollers mounted in hardened aluminium bearing blocks with sealed bearings
hydraulic cut-off unit
internally mounted power pack
the control system allows for sections of different lengths to be produced in continuous runs
pendant controller for manual control of forward, reverse and shear
powdercoated covers with sliding perspex windows
electrical safety switches to prevent the machine being run with the guards open
emergency stop buttons
3 x 5.5kW motor-gearbox